Model:ATS-801A |
Model: |
AC 220V(50Hz) |
Rate power |
about 3W |
Number could be counter |
-99999˜99999units |
Size: |
450(L)*180(W)*270(H)mm |
2) Features:
Automaticlly calculate the number of componentss to facilitate the point of material,made material operations
Dot-matrix LCD display screen in Chinese and English,the operation at a glance
Can be equipped with sensors to use my company for a pin resistors,capacitors and other electronic parts count.
SMD expected to take part can be common
Material with the input diameter:maximum 350mm
Tape spacing:2,4,8,12,16,32,44,56mm
3) Operation flow
1,Power line connection main engine, in joining-up AC220V power source.
2,Turns on the radio station kneading board's POWER power switch, this time the
LCD kneading board can send Bright.
3:Presses down PITCH, the components spacing which the hypothesis must count
4,According to “ENTER” key determination.
5,Will want the components which counts to install on the left side material plate.
6, Manual pulls out the material belt to clamp in keeps off between the material
piece and the counting gear, keeps off the material piece middle line the first
components and the blank space middle hole alignment
7,The key 2 seconds let the digit according to “the stop/reset” enull. Explained:
When drawing material belt counts the gear to be able to rotate the counting,
presses down this key to let the digit enull.
8,Presses down the SELECT cut choice manual and the automatic pattern, when
the choice automatic pattern must input wants to count the quantity, will
otherwise press “the clockwise” the motor not to rotate.
9,Circles with the hand drawing material belt it to the spatial material plate on.
10,Then counts according to “clockwise /RIGHT”
11,When quantity arrives, the motor can stop.
12,The law of inertia, counting quantity possibly many or is short in the
hypothesis value about approximately 1, available manual way reversing
rotation material plate to LCD demonstration setting value size, namely
components quantity
13,The counting finished presses “reverses /LEFT”, after expecting the belt again
rollback original left side material plate, namely stop revolving.